RAV Remote Analog Value Function Block
|
Remote Analog value (RAV) function blocks allow access to analog values from other devices on the network in a peer-to-peer fashion. These blocks are only available when there is a central MBus_ioFlash supervisor node present and active on the network.
Parameter | Description |
Name | Function block name, see common parameters |
Units | Parameter's engineering units, see common parameters |
Scale | Parameter's scale, see common parameters |
Format | Parameter's format, see common parameters |
|
DYN dynamic option, see common parameters |
Time-out Parameters: Time-out | The maximum time (optionally expressed in hours, minutes or seconds via radio buttons) between updates from the remote device. If the value is not refreshed within this time the remote device is considered off line and the block goes into a default state until the remote device resumes updates. |
Time-out Parameters: Default Value | The value to use when the block is in the default state. |
Network Parameter: Comm | COM port on which the device that contains the analog value is connected. |
Network Parameter: Dev addr | Modbus address of the device on the RS485 network that contains the analog value. |
Network Parameter: Block name | The name of the analog block within the device' program. |